Been using prusaslicers default PLA profile with issues and this is my first roll of PETG, so I just selected the corresponding profile for that.

It seems so be super stringy whenever there’s movement and when printing the bunny (in vase mode) there’s lots of holes in the model.

I’m not sure if this is an issue with calibration (didn’t do anything when switching from PLA) or if the filament is wet.

  • Hazdaz@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    That’s literally the first thing I thought of as well. A few times that I’ve mistakenly tried printing with a PLA profile while PETG was in the printer. Doesn’t get hot enough and really struggles to push the material through (for obvious reasons).

    • poofy_cat@lemm.ee
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      This could be it, OP should check what the actual temperature says on the screen during printing.