Been using prusaslicers default PLA profile with issues and this is my first roll of PETG, so I just selected the corresponding profile for that.

It seems so be super stringy whenever there’s movement and when printing the bunny (in vase mode) there’s lots of holes in the model.

I’m not sure if this is an issue with calibration (didn’t do anything when switching from PLA) or if the filament is wet.

  • drudoo@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Update: replaced the nozzle, heat block (heating element, sensor, PTFE) and fan duct. Did two new temp towers:

    Left tower is 235 (top) to 260 (layers labeled 280-260 are all 260). Right is 220-240.

    https://i.imgur.com/1MQkStE.jpg

    https://i.imgur.com/HDWq19A.jpg

    I definitely feel like 220 is the right temp for this.

    I’ll try the bunny again, the model is designed for vase mode, so it should work!

    • poofy_cat@lemm.ee
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      You could also mess with your retraction settings to try and reduce stringing.

    • poofy_cat@lemm.ee
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I had one weird roll of PETG that could only be printed at lower temperatures, so it’s possible. Still looks like the filament is wet to me… I recommend picking up a Sunlu S1 Plus when it drops under $40, I like being able to both dry the spool and print straight from the dryer (only takes a couple hours to re-absorb moisture).

      • drudoo@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        Dude! I just checked AliExpress for the Sunlu S1 Plus when I saw your message and was able to get one for $39 (shipped from Germany)! Thank you for that idea!