• Maalus@lemmy.world
    link
    fedilink
    arrow-up
    7
    ·
    7 months ago

    Snap the bolt before you ever strip the screw. I hate regular alan keys, torx should be the default everywhere. I did lose too many torx bits when impacting though

    • drkt@lemmy.dbzer0.com
      link
      fedilink
      arrow-up
      9
      ·
      edit-2
      7 months ago

      I’m actually conflicted; I have a lot more trouble with torx at work than I do alan, but phillips are universally a problem. The torx keys don’t stick in the hole and can’t be tilted at odd angles where as alan keys with a ball head can, and do stick in the hole to some degree which lets me free-spin it if I have clearance. I’ve ruined a lot more torx from over-torgue than I have alan keys. I would take torx over alan keys if it meant I never had to see a phillips again, though

      • Maalus@lemmy.world
        link
        fedilink
        arrow-up
        3
        ·
        7 months ago

        I have no idea how you managed to overtorque a torx honestly. Especially since you say alan key doesn’t do that. Alan keys are okay-ish when used on M5 and more. But stripping smaller screws than that is so common it’s almost useless. Also good alan keys have a small ball bearing on them on the ball side which lets you hold the screw on it or “free spin” as you call it.