I’m asking here since I assume a lot of you guys are running homelabs on Lenovo hardware.

I have two M720q Tiny that came with one 8 GB 2400MHz SoDIMM RAM each (see picture). I upgraded one to 2x 32 GB RAM and want to reuse the sticks in the other one for 16 GB in total and dual channel use. They have different FRU numbers (see picture) but I assume it’s the same marketing part number and I guess my plan works?

Can anyone confirm? I’m just unsure about dual channel since it’s not exactly the same RAM and I’m used to using exact pairs.

Thanks!

  • SpikesOtherDog@ani.social
    link
    fedilink
    English
    arrow-up
    17
    ·
    3 months ago

    You should not have any issues. Worst case scenario is that one is slower than the other and will cause the faster one to step down, but unless one is significantly slower, you should have no issues.

    Generally, in the past 10 years at least, mixed memory on dual channel configuration has not been an issue.

    • dan@upvote.au
      link
      fedilink
      English
      arrow-up
      4
      ·
      3 months ago

      Depends on if they’re the same speed. Faster memory has shorter clock cycles.

      It doesn’t really matter too much though. The system should just run all the memory at the slowest speed/timings.

  • Moonrise2473@feddit.it
    link
    fedilink
    English
    arrow-up
    3
    ·
    3 months ago

    On my m920q I used a random RAM stick and works fine. I would have returned it if it worked only with specific RAM sticks, even Apple didn’t do that

  • d00phy@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    3 months ago

    Compatible? Should be. Identical? No (at least not always). Only identical FRU are interchangeable.

    • catloaf@lemm.ee
      link
      fedilink
      English
      arrow-up
      8
      ·
      3 months ago

      That’s not strictly true. A board and CPU may not support all speeds, or mixed ranks. ECC and registered RAM would also fit but not necessarily work. There’s also low-power RAM that may not be compatible. Just because it fits, it doesn’t mean it’ll work.

      In OP’s case, it’s likely to be supported because it’s probably not ECC, registered, and consumer boards usually support the most common speeds. I don’t know how compatibility on low-power RAM goes.