I purchased an Ender 3S1 about two weeks ago now, and it seems like I’m having to level the bed after almost every single print.

The prints themselves are turning out fine, I just don’t know how to get my bed to stay level.

I purchased these as I thought they were supposed to help keep the bed in place

  • Nanomerce @lemmy.world
    link
    fedilink
    English
    arrow-up
    9
    ·
    1 year ago

    have you made sure your adjustment knobs are as tight as possible?

    I found that if I tightened all my knobs to max I could, then leveled by loosening some and adjusting the z offset, it would stay there for much longer.

    • GingeyBook@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      I’ll give this a shot, I was under the impression that you start with them as uncompressed as possible